Toyota T100 1996 Service Manual page 824

1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
Seal Packing
P14810
Z11442
Adhesive
P12478
− CYLINDER BLOCK
17. INSTALL REAR OIL SEAL RETAINER
(a) Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the retainer
and cylinder block.
Using a razor blade and gasket scraper, remove all
S
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
Thoroughly clean all components to remove all the
S
loose material.
Using a non−residue solvent, clean both sealing
S
surfaces.
(b) Apply seal packing to the retainer as shown in the illustra-
tion.
Seal packing:
Part No. 08826−00080 or equivalent
Install a nozzle that has been cut to a 2 − 3 mm (0.08
S
− 0.12 in.) opening.
HINT:
Avoid applying an excessive amount to the surface.
Parts must be assembled within 5 minutes of ap-
S
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein-
S
stall cap.
(c) Install the retainer with the 6 bolts.
Torque: 13.5 N·m (135 kgf·cm, 9.7 ft·lbf)
18. INSTALL LH ENGINE MOUNTING BRACKET
Install the bracket with the 5 bolts.
Torque:
Bolt A: 51 N·m (520 kgf·cm, 34 ft·lbf)
Bolt B: 20 N·m (200 kgf·cm, 14 ft·lbf)
19. INSTALL RH ENGINE MOUNTING BRACKET
Install the bracket with the 4 bolts.
Torque: 51 N·m (520 kgf·cm, 34 ft·lbf)
20. INSTALL OIL PRESSURE SWITCH
(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Part No. 08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
EM−101