Toyota T100 1996 Service Manual page 820

No.2, 4 Bearing Cap
2 or 4
No.1, 5 Bearing Cap
1 or 5
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
8.
(a)
NOTICE:
When installing the balance shaft make sure you support
the balance shaft with both hands and avoid scratching the
balance shaft bearing on the cylinder block side.
P14746
(b)
(c)
P14744
9.
(a)
P14804
(b)
HINT:
A number is marked on each main bearing cap to indicate the
installation position.
P14808
P14809
− CYLINDER BLOCK
INSTALL BALANCE SHAFTS
Install balance shafts.
Install the No.1 balance shaft with the bolt.
Install the No.2 balance shaft with the 2 bolts.
Torque: 18 N·m (185 kgf·cm, 13.4 ft·lbf)
INSTALL MAIN BEARINGS
Align the bearing claw with the claw groove of the cylinder
block, and push in the 5 upper bearings.
Align the bearing claw with the claw groove of the main
bearing cap, and push in the 5 lower bearings.
EM−97