Reverse Restrict Pin
SST
1996 TOYOTA T100 (RM449U)
MANUAL TRANSMISSION (W59)
REPLACEMENT
1.
(a)
(b)
Q04410
(c)
Slotted
Spring Pin
D00877
2.
(a)
WM0085
(b)
Q07553
−
EXTENSION HOUSING
IF NECESSARY, REPLACE REVERSE RESTRICT PIN
Remove the reverse restrict pin.
(1)
Using a hexagon wrench, remove the screw plug.
(2)
Using a pin punch and hammer, drive out the slotted
spring pin.
(3)
Pull off the lever housing and slide out the shaft.
Inspect the reverse restrict pin.
Turn and push the reverse restrict pin by hand.
Check for smooth operation.
Install the reverse restrict pin.
(1)
Install the lever housing.
(2)
Using a pin punch and hammer, drive in the slotted
spring pin, as shown.
(3)
Apply sealant to the plug threads.
Sealant:
Part No. 08833 − 00080, THREE BOND 1344, LOCTITE
242 or equivalent
(4)
Install and torque the screw plug.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
IF NECESSARY, REPLACE REAR BEARING OUTER
RACE
Using 2 screwdrivers, remove the snap ring.
Using SST, remove the outer race.
SST
09308−00010
MT−41
MT044−01