Toyota T100 1996 Service Manual page 1756

Inscribed Mark
Compressed Air
Inscribed Mark
1996 TOYOTA T100 (RM449U)
STEERING − POWER STEERING VANE PUMP (5VZ−FE)
If it is more than maximum, replace the plate and/or rotor with
one having the same mark stamped on the cam ring.
Inscribed mark: 1, 2, 3, 4 or None
HINT:
There are 5 vane plate lengths with the following rotor and cam
ring marks:
Rotor and
cam ring mark
R13897
None
1
2
3
4
3. INSPECT FLOW CONTROL VALVE
(a) Coat the valve with power steering fluid and check that it
falls smoothly into the valve hole by its own weight.
R12184
(b) Check the flow control valve for leakage.
Close one of the holes and apply compressed air 392 −
490 kPa (4 − 5 kgf/cm
and confirm that air does not come out from the end holes.
R07591
If necessary, replace the valve with one having the same letter
as inscribed on the front housing.
Inscribed mark: A, B, C, D, E or F
R12185
Vane plate Vane plate length mm
part number
14.999 − 15.001
44345−26010
(0.59051 − 0.59059)
14.997 − 14.999
44345−26020
(0.59043 − 0.59051)
14.995 − 14.997
44345−26030
(0.59035 − 0.59043)
14.993 − 14.995
44345−26040
(0.59027 − 0.59035)
14.991 − 14.993
44345−26050
(0.59020 − 0.59027)
2
, 57 − 71 psi) into the opposite side,
SR−49
(in.)