Toyota T100 1996 Service Manual page 1553

Left Right
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
REMOVAL
1.
A
2.
HINT:
FA0037
3.
HINT:
At the time of installation, tighten the adjusting nut to the bolt
protrusion length is of before removal.
R04273
4.
HINT:
At the time of installation, please refer to the following items.
R12264
5.
Remove the 2 torque arm mounting nuts.
R04275
− FRONT TORSION BAR SPRING (2WD)
REMOVE FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
MEASURE PROTRUDING BOLT END "A" AS SHOWN
Use this measurement for reference when adjusting the
S
vehicle height.
After stabilizing the suspension, adjust the vehicle height
S
by turning the adjusting nut (See page SA−7).
LOOSEN ADJUSTING NUT AND REMOVE ANCHOR
ARM
REMOVE TORSION BAR SPRING
There are left and right matchmarks on the rear end of the
S
torsion bar springs.
Be careful not to interchange them.
Apply a light coat of MP grease to the spline of the torsion
S
bar spring.
REMOVE TORQUE ARM
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
SA−83
SA0GN−01