Toyota T100 1996 Service Manual page 1022

SST
1996 TOYOTA T100 (RM449U)
SFI (5VZ−FE)
7.
(a)
P21154
P19985
(b)
Fulcrum Length
30 cm
NOTICE:
Do not rotate the fuel pipe, when tightening the flare nut.
FI1654
HINT:
Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
− SFI SYSTEM
FUEL SYSTEM
When disconnecting the high fuel pressure line, a large
amount of gasoline will spill out, so observe these proce-
dures:
(1) Disconnect the fuel pump connector.
(2) Start the engine. After the engine has stopped on
its own, turn the ignition switch to LOCK.
(3) Put a container under the connection.
(4) Slowly loosen the connection.
(5) Disconnect the connection.
(6) Plug the connection with a rubber plug.
When connecting the flare nut or union bolt on the high
pressure pipe union, observe these procedures:
(1) Union Bolt Type:
Always use 2 new gaskets.
(2) Union Bolt Type:
Tighten the union bolt by hand.
(3) Union Bolt Type:
Tighten the union bolt to the specified torque.
Torque: 34.3 N·m (350 kgf·cm, 25 ft·lbf)
(4) Flare Nut Type:
Apply a light coat of engine oil to the flare nut, and
tighten the flare nut by hand.
(5) Flare Nut Type:
Using SST, tighten the flare nut to specified torque.
SST 09631−22020
Torque:
34.3 N·m (350 kgf·cm, 25 ft·lbf)
28 N·m (285 kgf·cm, 21 ft·lbf) for using SST
Author :
SF−3
Date : 1009