Toyota T100 1996 Service Manual page 1489

Sealant
MP Grease
Outer
Inner
Bearing Bearing
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
INSTALLATION
1.
(a)
(b)
(c)
(d)
FA0028
(e)
(f)
2.
(a)
(b)
(c)
R12261
3.
Install the 3 bolts and tighten them.
4.
(a)
(b)
(c)
5.
Cap
R04135
− FRONT AXLE HUB (2WD)
INSTALL STEERING KNUCKLE
Support the lower suspension arm with a jack.
Install the steering knuckle to the upper ball joint and nut.
Push down the upper suspension arm and steering
knuckle and install the steering knuckle to the lower ball
joint and nut.
Torque the upper ball joint nut.
Torque: 108 N·m (1,100 kgf·cm, 80 ft·lbf)
Torque the lower ball joint nut.
Torque: 142 N·m (1,450 kgf·cm, 105 ft·lbf)
Install 2 new cotter pins.
CONNECT KNUCKLE ARM AND TO STEERING
KNUCKLE
Clean the threads of the bolts and steering knuckle with
toluene or trichloroethylene.
Apply sealant to the bolt threads.
Sealant:
Part No. 08833−00070, THREE BOND 1324 or equiva-
lent.
Tighten the 2 bolts.
Torque: 183 N·m (1,870 kgf·cm, 135 ft·lbf)
INSTALL DUST COVER
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
PACK BEARINGS WITH MP GREASE
Place MP grease in the palm of your hand.
Pack grease into the bearing, continuing until the grease
oozes out from the other side.
Employ the same manner around the bearing circumfer-
ence.
COAT INSIDE OF HUB AND CAP WITH MP GREASE
SA−19
SA0FL−01