Toyota T100 1996 Service Manual page 917

No. 1
No. 2
No. 3
No. 4
Mark F
No. 1
No. 2
No. 3
No. 4
No. 3 Crank Pin
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
Mark
1, 2 or 3
Mark
1, 2, 3, 4 or 5
Mark 0, 1 or 2
No. 4
Crank Pin
Z04969
− CYLINDER BLOCK
Standard clearance:
No.1
STD
U/S 0.25
Others
STD
U/S 0.25
Maximum clearance:
0.08 mm (0.0031 in.)
HINT:
If replacing the cylinder block subassembly, the bearing stan-
dard clearance will be:
No.1
0.010 − 0.049 mm (0.0004 − 0.0020 in.)
Others
0.014 − 0.053 mm (0.0006 − 0.0021 in.)
If the oil clearance is greater than maximum, replace the bear-
ings. If necessary, grind or replace the crankshaft.
HINT:
If using a standard bearing, replace with one having the same
number. If the number of the bearing cannot be determined, se-
lect the correct bearing by adding together the numbers im-
printed on the cylinder block and crankshaft, then selecting the
bearing with the same number as the total. There are 5 sizes
of standard bearings, marked "1", "2", "3", "4" and "5" according-
ly.
Cylinder block
Crankshaft
Use bearing
EXAMPLE: Cylinder block "2" + Crankshaft "1"
= Total number 3 (Use bearing "3")
Reference:
Standard sized bearing center wall thickness:
No.1
Mark "1"
Mark "2"
Mark "3"
Mark "4"
Mark "5"
0.020 − 0.038 mm (0.0008 − 0.0015 in.)
0.019 − 0.059 mm (0.0007 − 0.0023 in.)
0.024 − 0.042 mm (0.0009 − 0.0017 in.)
0.023 − 0.063 mm (0.0009 − 0.0025 in.)
Number marked
1
2
2 1
0 1 0
2 3 3
1 2
1.991 − 1.994 mm (0.0784 − 0.0785 in.)
1.994 − 1.997 mm (0.0785 − 0.0786 in.)
1.997 − 2.000 mm (0.0786 − 0.0787 in.)
2.000 − 2.003 mm (0.0787 − 0.0789 in.)
2.003 − 2.006 mm (0.0789 − 0.0790 in.)
EM−89
3
1 2
0
2
3
4 4 5