Toyota T100 1996 Service Manual page 1665

BR−28
1996 TOYOTA T100 (RM449U)
BRAKE − FRONT BRAKE CALIPER (2WD)
DISASSEMBLY
1. 1 ton:
REMOVE CALIPER SLIDING BUSHINGS AND DUST
BOOTS
(a) Remove the sliding bushings.
HINT:
At the time of reassembly, please refer to the following item.
Ensure that the boots are secured firmly to the caliper grooves.
(b) Using a screwdriver and a hammer, remove the dust
BR3384
boots.
HINT:
At the time of reassembly, please refer to the following item.
Use 2 socket wrenches and a vise, press in new dust boots.
2. REMOVE CYLINDER BOOT SET RING (1 ton) AND
CYLINDER BOOT
Using a screwdriver, remove the cylinder boot set ring (1 ton)
and cylinder boot.
BR3079
3. REMOVE PISTON FROM CYLINDER
(a) Put a piece of cloth or an equivalent between the piston
and caliper.
(b) Use compressed air to remove the piston from the cylin-
der.
CAUTION:
Do not place your fingers in front of the piston when using
compressed air.
BR0168
4. REMOVE PISTON SEAL FROM BRAKE CYLINDER
Using a screwdriver, remove the piston seal.
BR3080
BR099−02