Toyota T100 1996 Service Manual page 1535

SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
SA2351
SST
SA0339
SA0340
SA0370
− FRONT DIFFERENTIAL CARRIER (4WD)
Maximum torque: 235 N·m (2,400 kgf·cm, 173 ft·lbf)
If the maximum torque is exceeded while retightening the nut,
replace the spacer and repeat the preload procedure. Do not
loosen the nut to reduce the preload.
19. RECHECK RING GEAR BACKLASH
(See page SA−57)
20. RECHECK TOOTH CONTACT BETWEEN RING GEAR
AND DRIVE PINION (See page SA−57)
21. CHECK RUNOUT OF COMPANION FLANGE (See
page SA−48)
22. STAKE DRIVE PINION NUT
23. INSTALL RH SIDE GEAR SHAFT OIL SEAL
(a) Using SST and a hammer, install a new oil seal until its
surface is flush with the differential carrier end.
SST 09550−00032, 09950−70010 (09951−07150)
(b) Apply MP grease to the oil seal lip.
24. INSTALL RH SIDE GEAR SHAFT
(a) Install a new snap ring to the side gear shaft.
(b) Using a plastic hammer, install the side gear shaft to the
differential case.
25. CHECK INSTALLATION OF SIDE GEAR SHAFT
(a) Check that there is 2 − 3 mm (0.08 − 0.12 in.) of play in
axial direction.
(b) Check that the side gear shaft will not come out by trying
to pull it completely out by hand.
26. INSTALL INTERMEDIATE SHAFT
(a) Install a new snap ring to the shaft.
(b) Using a plastic hammer, install the shaft to the differential
case.
27. CHECK INSTALLATION OF INTERMEDIATE SHAFT
(a) Check that there is 2 − 3 mm (0.08 − 0.12 in.) of play in
the axial direction.
(b) Check that the intermediate shaft will not come out by try-
ing to pull it completely out by hand.
SA−65