Toyota T100 1996 Service Manual page 1613

SST
SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
14. CHECK DIFFERENTIAL CASE RUNOUT
(a) Install the differential case in the differential carrier (See
page SA−145).
(b) Using a dial indicator, measure the differential case run-
out.
Maximum case runout: 0.04 mm (0.0016 in.)
(c) Remove the differential case.
R04328
15. REMOVE SIDE BEARINGS
Using SST, remove the 2 side bearings from the differential
case.
SST
HINT:
Fix the claws of SST to the notch in the differential case.
R12920
16. DISASSEMBLE DIFFERENTIAL CASE ASSEMBLY
(a) Using a pin punch and hammer, remove the straight pin.
(b) Remove these parts from the differential case:
S
S
S
S
S
RA0997
− REAR DIFFERENTIAL CARRIER
09950−40010, 09950−60010 (09951−00450)
Pinion shaft
2 pinion gears
2 pinion gear thrust washers
2 side gears
2 side gear thrust washers
SA−143