TR−12
1996 TOYOTA T100 (RM449U)
TRANSFER
−
TRANSFER ASSEMBLY
(d)
Using a magnetic finger, remove the straight pin.
HINT:
At the time of installation, please refer to the following item.
Apply gear oil to the straight pin and insert it into the case hole.
TF0462
15.
REMOVE HIGH AND LOW FORK SHAFT, SHIFT FORK
AND STOPPER
HINT:
At the time of installation, please refer to the following items.
Place the high and low shift fork into the groove of the
S
clutch sleeve.
Make sure to install the shift fork in the correct direction.
S
16.
REMOVE REAR OUTPUT SHAFT, DRIVEN
SPROCKET AND CHAIN
(a)
Using a snap ring expander, remove the snap ring.
TF0464
(b)
Mount the rear case in the vise.
NOTICE:
Be careful not to damage the sealing surface.
(c)
Using a plastic hammer, tap the rear case with pulling the
rear output shaft and driven sprocket.
HINT:
At the time of installation, please refer to the following item.
If necessary, heat the rear case to about 70°C (158°F).
(d)
Remove the chain.
TF0465