Toyota T100 1996 Service Manual page 1085

CO−2
1996 TOYOTA T100 (RM449U)
COOLING (3RZ−FE)
Drain Plug
Drain Plug
P14901
− COOLANT
REPLACEMENT
1. REPLACE ENGINE COOLANT
(a) Remove the radiator cap.
CAUTION:
To avoid the danger of being burned, do not remove it while
the engine and radiator are still hot, as fluid and steam can
be blown out under pressure.
(b) Drain the coolant from the radiator drain plug and engine
drain plug. (Engine drain plug at the right of engine block.)
(c) Close the drain cock plug.
Torque:Torque (Engine drain plug):
24 N·m (250 kgf·cm, 18 ft·lbf)
2. FILL ENGINE COOLANT
(a) Slowly fill the system with coolant.
Use a good brand of ethylene−glycol base coolant
S
and mix it according to the manufacturer's direc-
tions.
Using coolant which includes more than 50 % ethyl-
S
ene−glycol (but not more than 70 %) is recom-
mended.
NOTICE:
Do not use an alcohol type coolant. The coolant should be
mixed with demineralized water or distilled water.
Capacity (w/ Heater):
8.7 liters (9.2 US qts, 7.7 lmp. qts)
(b) Reinstall the radiator cap.
(c) Warm up the engine and check for leaks.
(d) Recheck the coolant level and refill as necessary.
CO057−03