Toyota T100 1996 Service Manual page 1720

Torx Screw
Airbag Connector
Correct
R00606
R09597
Matchmarks
1996 TOYOTA T100 (RM449U)
STEERING
REMOVAL
Screw Case
1.
NOTICE:
S
S
R07659
(a)
(b)
(c)
HINT:
Loosen the 2 screws until the groove along the screw circumfer-
ence catches on the screw case.
(d)
CAUTION:
S
S
NOTICE:
When removing the wheel pad, take care not to pull the air-
bag wire harness.
Wrong
Z14903
2.
SST
(a)
(b)
(c)
(d)
R11211
− NON−TILT STEERING COLUMN
REMOVE STEERING WHEEL PAD
If the airbag connector is disconnected with the igni-
tion switch at ON or ACC, DTCs will be recorded.
Never use airbag parts from another vehicle. When
replacing parts, replace with new parts.
Place the front wheels facing straight ahead.
Remove the steering wheel lower No.2 and No.3 covers.
Using a torx socket wrench, loosen the 2 torx screws.
Pull the wheel pad out from the steering wheel and dis-
connect the airbag connector.
When storing the wheel pad, keep the upper surface
of the pad facing upward.
Never disassemble the wheel pad.
REMOVE STEERING WHEEL
Disconnect the connector.
Remove the steering wheel set nut.
Place matchmarks on the steering wheel and main shaft.
Using SST, remove the wheel.
SST 09950−50010 (09951−05010, 09952−05010,
09953−05020, 09954−05020)
SR−13
SR077−01