Toyota T100 1996 Service Manual page 805

EM−82
No.1
Balance Shaft
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
25.
(a)
(b)
(c)
NOTICE:
When removing the balance shaft make sure you support
the balance shaft with both hands and avoid scratching the
balance shaft bearing on the cylinder block side.
P14744
HINT:
S
S
No.2
Balance Shaft
P14748
26.
(a)
NOTICE:
Be careful not to damage the balance shaft.
P14753
(b)
Z11075
27.
(a)
NOTICE:
Be careful not to damage the balance shaft.
P14818
− CYLINDER BLOCK
REMOVE NO.1 AND NO.2 BALANCE SHAFTS
Remove the 1 bolt from the No.1 balance shaft.
Remove the 2 bolts from the No.2 balance shaft.
Remove the balance shafts.
No.1 balance shaft (RH):
Has indentations.
No.2 balance shaft (LH):
Has no indentations.
DISASSEMBLE NO.1 BALANCE SHAFT
Mount the hexagon wrench head portion of the balance
shaft in a vise.
Remove these parts from balance shaft assembly:
(1) No.1 balance shaft
(2) No.1 balance shaft thrust plate
(3) Balance shaft thrust spacer.
(4) Balance shaft timing gear.
(5) Key
DISASSEMBLE NO.2 BALANCE SHAFT
Mount the hexagon wrench head portion of the balance
shaft in a vise.