Toyota T100 1996 Service Manual page 1344

1996 TOYOTA T100 (RM449U)
MANUAL TRANSMISSION (W59)
INSPECTION
INSPECT SYNCHRONIZER RING
(a)
(b)
If the braking effect is insufficient, apply a small amount of the
fine lapping compound between the synchronizer ring and gear
cone. Lightly rub the synchronizer ring and gear cone together.
D00871
NOTICE:
Ensure the fine lapping compound is completely washed
off after rubbing.
(c)
(d)
If the clearance is less than the minimum, replace the synchro-
nizer ring, and apply a small amount of the fine lapping com-
pound on gear cone.
NOTICE:
Ensure the fine lapping compound is completely washed
off after rubbing.
D00872
− INPUT SHAFT
Check for wear or damage.
Check the braking effect of the synchronizer ring.
Turn the synchronizer ring in one direction while pushing
it to the gear cone. Check that the ring locks.
Check again the braking effect of the synchronizer ring.
Using a feeler gauge, measure the clearance between
the synchronizer ring back and gear spline end.
Minimum clearance: 0.5 mm (0.020 in.)
MT−19
MT03Q−01