Toyota T100 1996 Service Manual page 1744

SST
Bearing
1996 TOYOTA T100 (RM449U)
STEERING
DISASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
(a)
(b)
R12065
2.
Using SST to stop the pulley rotating, remove the pulley set nut.
3.
(a)
(b)
4.
Remove the O−ring from the union.
R09248
5.
(a)
(b)
6.
7.
8.
(a)
NOTICE:
Take care not to drop the plate.
(b)
9.
Remove the 2 pins from the front housing.
10.
11.
(a)
Vinyl Tape
(b)
Oil Seal
(c)
NOTICE:
Be careful not to damage the oil seal lip.
Z14482
− POWER STEERING VANE PUMP (3RZ−FE)
MEASURE PS VANE PUMP ROTATING TORQUE
Check that the pump rotates smoothly without abnormal
noise.
Using a torque wrench, check the pump rotating torque.
Rotating torque:
0.25 N·m (2.5 kgf·cm, 2.2 in.·lbf) or less
REMOVE VANE PUMP PULLEY
SST 09960−10010 (09962−01000, 09963−01000)
REMOVE OIL RESERVOIR
Remove the 3 bolts and oil reservoir.
Remove the O−ring from the oil reservoir.
REMOVE PRESSURE PORT UNION, FLOW CONTROL
VALVE AND SPRING
REMOVE REAR HOUSING
Remove the 2 bolts and rear housing.
Remove the 2 O−rings from the housing.
REMOVE WAVE WASHER
REMOVE SIDE PLATE
REMOVE CAM RING, VANE PLATES AND VANE
PUMP ROTOR
Remove the 10 plates.
Using a screwdriver, remove the snap ring from the vane
pump shaft.
REMOVE STRAIGHT PINS
REMOVE GASKET
REMOVE VANE PUMP SHAFT WITH BEARING
Using snap ring pliers, remove the snap ring from the front
housing.
Wind vinyl tape on the serrated part of the vane pump
shaft.
Using a press, press out the shaft with the bearing.
SR−37
SR07K−01