SA−20
SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
R12255
R04262
90°
R11763
90°
R11764
−
FRONT AXLE HUB (2WD)
6.
INSTALL INNER BEARING AND OIL SEAL
(a)
Place inner bearing into the axle hub.
(b)
Using SST and a hammer, install a new oil seal into the
hub.
SST
09950−60020 (09951−00710),
09950−70010 (09951−00150)
NOTICE:
Be careful not to damage the ABS speed sensor rotor.
(c)
Coat the oil seal lip with MP grease.
7.
INSTALL AXLE HUB WITH DISC
(a)
Place the axle hub on the spindle.
(b)
Install the outer bearing and thrust washer.
8.
ADJUST PRELOAD
(a)
Install and torque the nut.
Torque: 35 N·m (360 kgf·cm, 26 ft·lbf)
(b)
Turn the hub several times to make the bearing more
smoothly
(c)
Loosen the nut until it can be turned by hand.
(d)
Using a spring tension gauge, measure and make a note
of the frictional force of the oil seal.
Preload (at starting): 4.0 N (0.4 kgf, 0.9 lbf) or less
HINT:
Make sure to check preload in the direction of rotation.
(e)
Tighten the nut until the preload is within specification.
Preload (at starting) :
Frictional force plus
5.0 − 14.0 N (0.5 − 1.4 kgf, 1.1 − 3.1 lbf)
HINT:
Make sure to check preload in the direction of rotation.