Toyota T100 1996 Service Manual page 804

1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
(k)
22.
(a)
(b)
HINT:
Arrange the main bearings and thrust washers in correct order.
23.
P14796
24.
Using a dial indicator, measure the thrust clearance while mov-
ing the balance shaft back and forth.
If the thrust clearance is greater than maximum, replace the bal-
P14745
ance shaft thrust washer.
If necessary, replace the balance shaft.
− CYLINDER BLOCK
Crankshaft Journal diameter:
STD NO.3
STD Others
U/S 0.25 No.3
U/S 0.25 Others
Bearing center wall thickness:
STD Mark "1"
STD Mark "2"
STD Mark "3"
U/S 0.25
Completely remove the Plastigage.
REMOVE CRANKSHAFT
Lift out the crankshaft.
Remove the upper main bearings and upper thrust wash-
ers from the cylinder block.
REMOVE CYLINDER BLOCK ORIFICE
CHECK THRUST CLEARANCES OF NO.1 AND NO.2
BALANCE SHAFTS OF ENGINE BALANCER
Standard thrust clearance:
0.07 − 0.13 mm (0.0027 − 0.0051 in.)
Maximum thrust clearance:
0.2 mm (0.0079 in.)
59.981 − 59.994 mm (2.2615 − 2.3620 in.)
59.987 − 60.000 mm (2.3617 − 2.3622 in.)
59.740 − 59.750 mm (2.3520 − 2.3524 in.)
59.745 − 59.755 mm (2.3522 − 2.3526 in.)
1.987 − 1.990 mm (0.0782 − 0.0783 in.)
1.991 − 1.993 mm (0.0784 − 0.0785 in.)
1.994 − 1.996 mm (0.0785 − 0.0786 in.)
2.106 − 2.112 mm (0.0829 − 0.0831 in.)
EM−81