Toyota T100 1996 Service Manual page 1334

1996 TOYOTA T100 (RM449U)
MANUAL TRANSMISSION (W59)
(c)
8.
(a)
(b)
NOTICE:
At the time of reassembly, please refer to the following
item.
FIPG
Align each bearing outer race and each shift fork shaft end
Q06716
with the case holes.
9.
(a)
HINT:
Increase or decrease plate washers so that the bolt tip does not
protrude from the nut.
(b)
10.
Remove the 2 bolts and oil separator.
Q03881
11.
− MANUAL TRANSMISSION ASSEMBLY
FIPG:
Part No. 08826 − 00090, THREE BOND 1281 or equiva-
lent
Using a snap ring expander, remove the 2 bearing snap
rings.
SEPARATE INTERMEDIATE PLATE FROM TRANS-
MISSION CASE
Using a plastic hammer, carefully tap the transmission
case.
Pull the transmission case from the intermediate plate.
FIPG:
Part No. 08826 − 00090, THREE BOND 1281 or equiva-
lent
MOUNT INTERMEDIATE PLATE IN VISE
Use the 2 long clutch housing bolts, plate washers and
suitable nuts, as shown.
Mount the intermediate plate in a vise.
REMOVE OIL SEPARATOR
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
REMOVE FRONT MAGNET
MT−9