Toyota T100 1996 Service Manual page 1737

SR−30
SST
Mark Position
1996 TOYOTA T100 (RM449U)
STEERING
REASSEMBLY
SST
NOTICE:
When using a vise, do not overtighten it.
1.
2.
(a)
R11780
(b)
(c)
NOTICE:
Do not bend the universal joint of the main shaft more than
20°.
(d)
3.
Torque the 2 bolts.
4.
Select the bolt with the hollow−tipped thread end when the col-
Hollow Tipped
umn upper tube mark is 1, and the bolt with the plain thread end
when the mark is 2.
1
NOTICE:
Select the bolt type to match each number marked in the
2
squares on the upper tube.
R13024
5.
(a)
(b)
R04528
(c)
6.
Torque the tilt lever assembly set bolt.
R04529
− TILT STEERING COLUMN
COAT WITH MOLYBDENUM DISULFIDE LITHIUM
BASE GREASE
(See pages SR−23)
INSTALL MAIN SHAFT ASSEMBLY
Install the bearing, bearing thrust collar and compression
spring to the main shaft.
Install the main shaft into the column upper tube.
Using SST, compress the compression spring.
SST 09950−40010 (09957−04010, 09958−04010)
Using a snap ring expander, install a new snap ring.
INSTALL TURN SIGNAL BRACKET
Torque: 7.8 N·m (80 kgf·cm, 69 in.·lbf)
SELECT 2 TILT NO.2 BOLTS
INSTALL COLUMN UPPER TUBE WITH MAIN SHAFT
ASSEMBLY
Install the stopper and collar to the shaft assembly.
Install the upper tube with the shaft assembly to the col-
umn lower tube.
Using a plastic hammer, drive in the 2 tilt No.2 bolts.
INSTALL TILT LEVER LOCK SHAFT, TILT LEVER
ASSEMBLY AND TILT SUB LEVER, TILT LEVER
Torque: 2 N·m (20 kgf·cm, 17 in.·lbf)
SR07G−01