PR−14
Front Propeller Shaft
Rear Propeller Shaft
Front
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT
−
REASSEMBLY
HINT:
When removing or installing any part, make sure that each joint
is facing to the correct direction, as shown in the illustration be-
low.
1.
Frsont:
INSERT SLEEVE YOKE INTO FRONT PROPELLER
SHAFT
(a)
Apply MP grease to the propeller shaft spline and sleeve
yoke sliding surface.
(b)
Align the matchmarks on the sleeve yoke and propeller
shaft.
(c)
Insert the sleeve yoke into the propeller shaft.
2.
Rear:
INSTALL CENTER SUPPORT BEARING ON INTER-
MEDIATE SHAFT
HINT:
Install the center support bearing in the direction, as shown.
PR0036
PROPELLER SHAFT ASSEMBLY (4WD)
PR01Q−01
Z03924