Toyota T100 1996 Service Manual page 1659

BR−22
1996 TOYOTA T100 (RM449U)
BRAKE − FRONT BRAKE PAD (2WD)
REPLACEMENT
1. REMOVE FRONT WHEEL
Remove the wheel and temporarily fasten the disc with hub
nuts.
2. INSPECT PAD LINING THICKNESS
Check the pad thickness through the caliper inspection hole
and replace pads if not within specification.
Minimum thickness: 1.0 mm (0.039 in.)
BR3082
3. LIFT UP CALIPER
(a) Remove the installation bolt.
(b) Lift up the caliper and suspend it securely.
HINT:
Do not disconnect the flexible hose from the caliper.
4. REMOVE THESE PARTS:
1 ton:
S
2 anti−squeal springs
2 brake pads
S
R04837
2 (1 ton) / 4 (0.5 ton) anti−squeal shims
S
2 pad wear indicator plates
S
4 pad support plates
S
NOTICE:
The anti−squeal springs (1 ton) and support plates can be
used again provided that they have sufficient rebound, no
deformation, cracks or wear, and have had all rust, dirt and
foreign particles cleaned off.
5. CHECK DISC THICKNESS AND RUNOUT
(See page BR−30)
6. INSTALL 4 PAD SUPPORT PLATES
7. INSTALL NEW PADS
NOTICE:
When replacing worn pads, the anti−squeal shims and
wear indicator plates must be replaced together with the
pads.
(a) Install a pad wear indicator plate to the pad.
(b) 1 ton:
Install the anti−squeal shim to each pad.
(c) 0.5 ton:
Install the 4 anti−squeal shims to each pad.
HINT:
Apply disc brake grease to both sides of inner anti−squeal
shims (See page BR−21).
BR3312
BR094−01