Toyota T100 1996 Service Manual page 1602

SA−132
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
INSPECTION
1.
(a)
NOTICE:
Do not reuse the nuts previously removed from the vehicle.
R12297
(b)
2.
Using a snap ring expander, remove the snap ring.
R12298
3.
SST
(a)
(b)
(c)
SA0528
(d)
(e)
SST
RA0177
4.
If the rear axle shaft or flange are damaged or worn, or if runout
is greater than the maximum, replace the rear axle shaft.
R12254
− REAR AXLE SHAFT
w/ ABS:
REMOVE BEARING RETAINER (DIFFERENTIAL SIDE)
AND ABS SPEED SENSOR ROTOR
Attach 4 nuts to the serration bolts and remove the serra-
tion bolts from the backing plate using a hammer.
Grind the retainer and sensor rotor surfaces using a grind-
er, then chisel them out with a chisel.
REMOVE SNAP RING FROM AXLE SHAFT
REMOVE REAR AXLE SHAFT FROM BACKING
PLATE
Attach 4 washers and nuts to the serration bolts, then
torque the nuts to install the serration bolts to the backing
plate.
Remove the 4 nuts from the serration bolts.
Position SST on the backing plate with 4 nuts.
SST 09521−25011
Using a press, remove the rear axle shaft with bearing re-
tainer from the backing plate.
Remove the SST.
INSPECT AXLE SHAFT AND FLANGE FOR RUNOUT
FOR WEAR, DAMAGE OR RUNOUT
Maximum:
Shaft runout: 2.0 mm (0.079 in.)
Flange runout: 0.1 mm (0.004 in.)
SA0HZ−01