Cylinder Block Replacement - Toyota T100 1996 Service Manual

EM−100
Cut Position
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
REPLACEMENT
1.
2.
HINT:
There are 2 methods (A and B) to replace the oil seal which are
as follows:
(a)
EM5252
SST
EM5251
(b)
NOTICE:
Be careful not to damage the crankshaft. Tape the screw-
driver tip.
Z04104
SST
EM7574
− CYLINDER BLOCK
REPLACE CRANKSHAFT FRONT OIL SEAL
(See page EM−100)
REPLACE CRANKSHAFT REAR OIL SEAL
If rear oil seal retainer is removed from cylinder block.
(1) Using a screwdriver and hammer, tap out the oil
seal.
(2) Using SST and a hammer, tap in a new oil seal until
its surface is flush with the rear oil seal retainer
edge.
SST 09223−15030, 09950−70010 (09951−07150)
(3) Apply MP grease to the oil seal lip.
If rear oil seal retainer is installed to cylinder block.
(1) Using a knife, cut off the oil seal lip.
(2) Using a screwdriver, pry out the oil seal.
(3) Apply MP grease to a new oil seal lip.
(4) Using SST and a hammer, tap in the oil seal until its
surface is flush with the rear oil seal retainer edge.
SST 09223−15030, 09950−70010 (09951−07150)
EM07B−04