Toyota T100 1996 Service Manual page 1134

LU−10
SST
SST
1996 TOYOTA T100 (RM449U)
LUBRICATION (3RZ−FE)
REPLACEMENT
REPLACE CRANKSHAFT FRONT OIL SEAL
HINT:
There are 2 methods (A and B) to replace the oil seal which are
as follows:
(a) If oil pump is removed from cylinder block.
(1)
P14862
(2)
SST
(3)
P14864
(b) If oil pump is installed to cylinder block.
(1)
NOTICE:
Be careful not to damage the crankshaft. Tape the screw-
driver tip.
P14861
(2)
(3)
SST
P14863
− OIL PUMP
Using a screwdriver and a hammer, tap out the oil
seal.
Using SST and a hammer, tap in a new oil seal until
its surface is flush with the oil pump case edge.
09223−50010
Apply MP grease to the oil seal lip.
Using a screwdriver, pry out the oil seal.
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump case edge.
09223−50010
LU02Z−02