Toyota T100 1996 Service Manual page 1146

SST
1996 TOYOTA T100 (RM449U)
LUBRICATION (5VZ−FE)
REMOVAL
HINT:
When repairing the oil pump, the oil pan and strainer should be
removed and cleaned.
1. REMOVE CRANKSHAFT TIMING PULLEY
(See page EM−13)
2. 4WD:
REMOVE FRONT DIFFERENTIAL
3. DRAIN ENGINE OIL
4. A/T:
REMOVE OIL COOLER TUBE AND CLAMP
(See page AT−28)
5. REMOVE STIFFENER PLATE
6. REMOVE FLYWHEEL HOUSING UNDER AND COVER
DUST
7. DISCONNECT STARTER WIRE CLAMP
8. REMOVE CRANKSHAFT POSITION SENSOR
9. REMOVE OIL PAN
(a) Remove the 15 bolts and 4 nuts.
(b) Using SST and a brass bar, separate the oil pan from the
cylinder block.
SST
HINT:
When removing the oil pan, be careful not to damage the oil pan
SST
flange.
Z04119
10. REMOVE OIL STRAINER
Remove the 2 bolts, 2 nuts and oil strainer and gasket.
11. REMOVE OIL PAN BAFFLE PLATE
Remove the 2 bolt, nut and oil pan baffle plate.
P20974
12. REMOVE OIL PUMP
(a) Remove the 8 bolts, ground strap and oil pump.
(b) Using a plastic−faced hammer, carefully tap the oil pump
body.
(c) Remove the O−ring from the cylinder block.
P20973
− OIL PUMP
09032−00100
LU−9
LU036−03