Toyota T100 1996 Service Manual page 1775

SR−68
Clockwise
5.4N·m
(55kgf·cm, 4.8in.·lbf)
SST
Torque
Wrench
Fulcrum
Length
1996 TOYOTA T100 (RM449U)
Counterclckwise
SST
STEERING − POWER STEERING GEAR (2WD)
(h) Using a hexagon wrench (21 mm), gradually tighten the
rack guide spring cap and adjust the twist of the steering
rack to 0.08 mm (0.0032 in.) or less when the rack is
twisted clockwise and counterclockwise by SST and
torque wrench with 5.4 N·m (55 kgf·cm, 48 in.·lbf) of
torque applied.
SST 09922−10010
NOTICE:
Use SST 09922−10010 in the direction shown in the illustra-
tion
HINT:
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
(i) Using SST to ratate the control valve shaft, adjust the
twist of the rack so that it is within the above specifications
at the following 5 points:
SST 09616−00010
(1) Steering rack at center position.
(2) Steering pinion shaft rotated 90° clockwise from the
center position.
(3) Steering pinion shaft rotated 90° counterclockwise
from the center position.
(4) Steering pinion shaft rotated 180° clockwise from
the center position.
(5) Steering pinion shaft rotated 180° counterclock-
wise from the center position.
Dial Indicator
0.08mm(0.0032in.) or less
Dial Indicator
Twist of Steering Rack
Steering Rack Center Position
90°
90°
180°
180°
Steering
Rack
Control
Value
Shaft
SST
R15452