Toyota T100 1996 Service Manual page 1106

CO−2
Drain Plug
1996 TOYOTA T100 (RM449U)
COOLING (5VZ−FE) − COOLANT
REPLACEMENT
1. DRAIN ENGINE COOLANT
(a) Remove the radiator cap.
CAUTION:
To avoid the danger of being burned, do not remove the ra-
diator cap while the engine and radiator are still hot, as fluid
and steam can be blown out under pressure.
(b) Loosen the drain plugs, and drain the engine coolant.
(c) Close the drain plugs.
P20925
2. FILL ENGINE COOLANT
(a) Slowly fill the system with engine coolant.
Use a good brand of ethylene−glycol base engine
S
coolant and mix it according to the manufacturer's
directions.
Using engine coolant which includes more than 50
S
% ethylene−glycol (but not more than 70 %) is rec-
ommended.
NOTICE:
Do not use an alcohol type engine coolant.The engine cool-
ant should be mixed with demineralized water or distilled
water.
Capacity:
2WD
M/T 10.0 liters (10.6 US qts, 8.8 lmp. qts)
A/T 9.9 liters (10.5 US qts, 8.7 lmp. qts)
4WD
M/T 10.0 liters (10.6 US qts, 8.8 lmp. qts)
A/T 10.2 liters (10.8 US qts, 9.0 lmp. qts)
(b) Install the radiator cap.
(c) Start the engine, and bleed the cooling system.
(d) If necessary, refill engine coolant into the reservoir tank
until it is "FULL" line.
3. CHECK ENGINE COOLANT FOR LEAKS
CO05P−04