Toyota T100 1996 Service Manual page 897

Engine Hanger No.2
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
INSTALLATION
1.
2.
(a)
(b)
P21457
(c)
(d)
(e)
P21459
(f)
(g)
(h)
P21444
3.
(a)
(b)
(c)
(d)
P15099
4.
Tighten the 4 bolts and nuts holding the mounting insulators to
the body mountings.
P23911
− ENGINE UNIT (2WD)
INSTALL TRANSMISSION TO ENGINE
(See page AT−26)
INSTALL ENGINE AND TRANSMISSION ASSEMBLY
IN VEHICLE
Attach the engine hoist chain to the engine hangers.
Lower the engine and transmission assembly into the en-
gine compartment.
Keep the engine level, and align the RH and LH mount-
ings and body mountings.
Attach the RH and LH mounting insulators to the body
mountings, and temporarily install the 4 bolts and nuts.
Jack up and put the transmission onto the frame.
Remove the engine chain hoist from the engine.
Remove the 2 bolts and engine hanger No.2.
w/ A/C:
Install the bolt, and connect the A/C compressor wire.
INSTALL ENGINE REAR MOUNTING BRACKET
Raise the transmission slightly by raising the engine with
a jack and a wooden block under the transmission.
Install the engine rear mounting bracket to the frame.
Torque: 58 N·m (590 kgf·cm, 43 ft·lbf)
Lower the transmission and rest it on the extension hous-
ing.
Install the mounting bracket to the mounting insulator.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
TIGHTEN RH AND LH ENGINE MOUNTING
INSULATOR BOLTS AND NUTS
Torque: 38 N·m (387 kgf·cm, 28 ft·lbf)
EM−69
EM1OS−01