IG−8
1996 TOYOTA T100 (RM449U)
IGNITION (3RZ−FE)
−
DISTRIBUTOR
DISASSEMBLY
1.
REMOVE ROTOR
2.
REMOVE IGNITION COIL DUST COVER
(a)
Remove the dust cover.
(b)
Remove the dust proof packing.
HINT:
At the time of reassembly, please refer to the following item. Use
new dust proof packing.
3.
REMOVE IGNITION COIL
(a)
Remove the 2 nuts, and disconnect the 3 wires from the
ignition coil terminals.
NOTICE:
At the time of reassembly, please refer to the following
items.
When connecting the wires to the ignition coil, insert
S
the properly into the groove found on the side of the
ignition coil.
Be sure the wire do not contact with signal rotor or
S
distributor housing.
(b)
Remove the 4 screws and ignition coil.
NOTICE:
At the time of reassembly, please refer to the following
items.
Apply seal packing to the ignition coil installing serface of
the housing, as shown in the illustration.
Seal packing: Part No. 08826 − 00080 or equivalent
IG0LA−01