Toyota T100 1996 Service Manual page 886

EM−58
L = 165 mm (6.50 in.) L = 165 mm (6.50 in.)
Join Line
L = 130 mm
(5.12 in.)
L = 265 mm
(10.43 in.)
L = Length
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
(d)
(e)
16.
17.
(a)
(b)
(c)
18.
P21192
19.
(a)
If the gaskets do have cracks or peeling etc., replace them us-
ing these steps:
(b)
20.
Join Line
L = 145 mm
(5.71 in.)
P21198
− CYLINDER HEAD
Install the dipstick guide with the 2 bolts.
Torque: 8 N·m (80 kgf·cm, 71 in.·lbf)
Install the dipstick.
INSTALL PS PUMP BRACKET
Torque: 18.5 N·m (185 kgf·cm, 13 ft·lbf)
INSTALL INTAKE MANIFOLD ASSEMBLY
Install 2 new gaskets and the intake manifold, delivery
pipe and injectors assembly with the 8 bolts, 4 plate wash-
ers and 4 nuts.
Torque: 18 N·m (180 kgf·cm, 13 ft·lbf)
Install the intake manifold stay with the 2 bolts.
Torque: 18.5 N·m (185 kgf·cm, 13 ft·lbf)
Connect the fuel inlet hose.
INSTALL FUEL PRESSURE REGULATOR
(See page SF−16)
INSTALL NO.3 TIMING BELT COVER
Check that the timing belt cover gaskets have no cracks
or peeling, etc.
Using a screwdriver and gasket scraper, remove all
S
the old gasket material.
Thoroughly clean all components to remove all the
S
loose material.
Remove the backing paper from a new gasket and
S
install the gasket evenly to the part of the timing belt
cover shaded black in the illustration.
Install the timing belt cover with the 6 bolts.
Torque: 9 N·m (90 kgf·cm, 80 in.·lbf)
INSTALL CAMSHAFT POSITION SENSOR
Torque: 8 N·m (80 kgf·cm, 71 in.·lbf)