Toyota T100 1996 Service Manual page 1522

SA−52
SST
Front
Matchmarks
SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
R02482
Rear
W00401
FA1998
SST
R11392
− FRONT DIFFERENTIAL CARRIER (4WD)
20. REMOVE DRIVE PINION FRONT BEARING
Using SST and a press, remove the bearing from the drive pin-
ion.
SST 09950−00020
HINT:
If the drive pinion or ring gear are damaged replace them as a
set.
21. REMOVE DRIVE PINION BEARING OUTER RACES
Using a brass bar and hammer, remove the 2 outer races from
the differential carrier.
22. REMOVE RING GEAR
(a) Place matchmarks on the ring gear and differential case.
(b) Using a screwdriver and hammer, unstake the lock plates.
(c) Remove the 10 bolts and 5 lock plates.
(d) Using a plastic hammer, tap on the ring gear to separate
it from the differential case.
23. REMOVE SIDE BEARINGS
Using SST, remove the 2 side bearings from the differential
case.
SST 09950−40010, 09950−60010 (09951−00480)
HINT:
Fix the claws of SST to the notch in the differential case.
24. DISASSEMBLE DIFFERENTIAL CASE ASSEMBLY
(a) Using a pin punch and hammer, remove the straight pin.
(b) Remove these parts from the differential case:
Pinion shaft
S
2 pinion gears
S
2 pinion gear thrust washers
S
2 side gears
S
2 side gear thrust washers
S