Generator Disassembly - Toyota T100 1996 Service Manual

CH−8
SST (B)
1996 TOYOTA T100 (RM449U)
CHARGING (3RZ−FE) −
DISASSEMBLY
1. REMOVE REAR END COVER
(a) Remove the nut and terminal insulator.
(b) Remove the 3 nuts and end cover.
P13397
2. REMOVE BRUSH HOLDER
(a) Remove the 2 screws, brush holder and cover.
(b) Remove the brush holder cover from the brush holder.
P13398
3. REMOVE VOLTAGE REGULATOR
Remove the 3 screws and voltage regulator.
P13396
4. REMOVE RECTIFIER HOLDER
(a) Remove the 4 screws and rectifier holder.
(b) Remove the 4 rubber insulators.
P20344
5. REMOVE PULLEY
SST (A)
(a) Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
(b) Check that SST (A) is secured to the rotor shaft.
CH0213
GENERATOR
09820−63010
CH0ES−02