SST
SST
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
REPLACEMENT
1.
HINT:
There are 2 methods (A and B) to replace the oil seal which are
as follows:
(a)
P14862
P14864
(b)
NOTICE:
Be careful not to damage the crankshaft.
Tape the screwdriver tip.
P14861
P14863
2.
(a)
P14984
−
CYLINDER BLOCK
REPLACE CRANKSHAFT FRONT OIL SEAL
If oil pump is removed from cylinder block.
(1)
Using a screwdriver and a hammer, tap out the oil
seal.
(2)
Using SST and a hammer, tap in a new oil seal until
its surface is flush with the oil pump case edge.
SST
09223 − 50010
(3)
Apply MP grease to the oil seal lip.
If oil pump is installed to the cylinder block.
(1)
Using a screwdriver, pry out the oil seal.
(2)
Apply MP grease to a new oil seal lip.
(3)
Using SST and a hammer, tap, in the oil seal until
its surface is flush with the oil pump case edge.
SST
09223 − 50010
REPLACE CRANKSHAFT REAR OIL SEL
If rear oil seal retainer is removed from cylinder block.
(1)
Using a screwdriver and a hammer, tap out the oil
seal.
EM−93
EM07N−02