Toyota T100 1996 Service Manual page 1778

1996 TOYOTA T100 (RM449U)
STEERING
INSTALLATION
1.
Torque the 2 gear assembly set bolts and nut.
2.
(a)
(b)
3.
SST
(a)
(b)
Fulcum Length
HINT:
R15251
S
S
4.
5.
6.
Install the nut and a new cotter pin.
7.
HINT:
Do it with the front of the vehicle jacked up.
8.
9.
(a)
(b)
(c)
10.
11.
12.
13.
14.
− POWER STEERING GEAR (2WD)
INSTALL PS GEAR ASSEMBLY
Torque: 88 N·m (900 kgf·cm, 65 ft·lbf)
INSTALL MOUNT BRACKET AND GROMMET
Install the grommet and mount bracket to the PS gear as-
sembly.
Torque the 2 bolts.
Torque: 88 N·m (900 kgf·cm, 65 ft·lbf)
CONNECT PRESSURE FEED TUBE AND INSTALL
RETRUN TUBE
Coat a new O−ring with power steering fluid and install it
to the tube.
Using SST, connect the pressure feed tube and install the
return tube.
SST 09631−22020
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
Use a torque wrench with a fulcrum length of 250 mm
(9.84 in.).
This torque value is effective in case that SST is parallel
to a torque wrench.
CONNECT RETURN HOSE
CONNECT INTERMEDIATE SHAFT ASSEMBLY
(See page SR−20)
CONNECT RH AND LH TIE ROD ENDS
Torque: 90 N·m (920 kgf·cm, 67 ft·lbf)
POSITION FRONT WHEELS FACING STRAIGHT
AHEAD
CENTER SPIRAL CABLE
(See page SR−20)
INSTALL STEERING WHEEL
Align the matchmarks on the wheel and steering column
main shaft.
Temporarily tighten the wheel set nut.
Connect the connector.
BLEED POWER STEERING SYSTEM
(See page SR−4)
CHECK STEERING WHEEL CENTER POINT
TORQUE STEERING WHEEL SET NUT
Torque: 35 N·m (360 kgf·cm, 26 ft·lbf)
INSTALL STEERING WHEEL PAD
(See page SR−20)
CHECK FRONT WHEEL ALIGNMENT
(See page SA−7)
SR−71
SR07Z−01