Toyota T100 1996 Service Manual page 1456

Matchmarks
TMC
90
DANA
90
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT
INSTALLATION
1.
(a)
(b)
(c)
HINT:
Make sure the bearing is installed with facing the drain hole
downwards.
(d)
(e)
R15507
2.
Bracket Center
HINT:
Line
S
S
S
Shaft Axial
Direction
R04434
Torque the 2 bolts.
Bracket Center
Line
Shaft Axial
Direction
R04435
− PROPELLER SHAFT ASSEMBLY (2WD)
INSTALL PROPELLER SHAFT
Remove SST from the transmission.
SST 09325−40010
Insert the yoke into the transmission.
Temporarily install the center support bearing with 2
mounting bolts.
Align the matchmarks on the flanges and connect the
flanges with the 4 bolts, washers and nuts.
Torque the 4 bolts.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
ADJUST CENTER SUPPORT BEARING
With the vehicle unladen, adjust the center support bear-
ing to keep the intervals, as shown.
At the same condition, check the center line in the axial
direction. Adjust the bearing if necessary.
Check that the center line of the center bearing is set to
the center line of the bracket when the vehicle is unladen.
Adjust the bracket if necessary.
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
PR−9
PR07Z−01