Toyota T100 1996 Service Manual page 1464

9 0
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT
3.
Bracket Center
HINT:
Line
Shaft Axial
Direction
R04482
(a)
(b)
− PROPELLER SHAFT ASSEMBLY (4WD)
ADJUST CENTER SUPPORT BEARING
With the vehicle unladen, adjust the center support bear-
S
ing to keep the intervals, as shown.
At the same condition, check the center line in the axial
S
direction. Adjust the bearing if necessary.
Check that the center line of the center bearing is set to
S
the center line of the bracket when the vehicle is unladen.
Adjust the bracket if necessary.
Torque the 2 bolts.
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
Install propeller shaft protector with 4 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
PR−17