Toyota T100 1996 Service Manual page 1530

SA−60
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
(e) Using a torque wrench, measure the preload.
Preload (at starting):
New bearing:
1.2 − 1.9 N·m (12 − 19 kgf·cm, 10.4 − 16.5 in.·lbf)
Reused bearing:
0.6 − 1.0 N·m (6 − 10 kgf·cm, 5.2 − 8.7 in.·lbf)
SA2352
9. INSTALL DIFFERENTIAL CASE IN DIFFERENTIAL
CARRIER
(a) Place the 2 bearing outer races on their respective bear-
ings. Check that the left and right outer races are not inter-
changed.
(b) Install the differential case in the differential carrier.
10. ADJUST RING GEAR BACKLASH
(a) Only install the plate washer on the ring gear back side.
HINT:
FA0743
Make sure that the ring gear has backlash.
(b) Tap on the ring gear with a plastic hammer so that the
washer fit to the bearing.
FA0744
(c) Using a dial indicator, measure the side gear backlash
with holding one pinion gear toward the differential case.
Backlash (reference): 0.13 mm (0.0051 in.)
FA0746
(d) Select a plate washer for back side ring gear, using the
backlash as reference (See page SA−57).
FA0743
− FRONT DIFFERENTIAL CARRIER (4WD)