Toyota T100 1996 Service Manual page 1508

SA−38
Matchmarks
Matchmarks
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
DISASSEMBLY
1. CHECK DRIVE SHAFT
(a) Check to see there is no play in the inboard and outboard
joints.
(b) Check to see that the inboard joint slides smoothly in the
thrust direction.
(c) Check to see that there is no obvious play in the radial
direction of the universal joints.
(d) Check the boot for damage.
FA0810
2. REMOVE INBOARD AND OUTBOARD JOINT BOOT
CLAMPS
(a) Using a screwdriver, remove the 4 boot clamps.
(b) Slide the inboard joint boot toward the outboard joint.
3. DISASSEMBLE INBOARD JOINT TULIP
(a) Place matchmarks on the inboard joint tulip and drive
shaft.
(b) Remove the inboard joint tulip from the drive shaft.
FA0838
4. DISASSEMBLE TRIPOD
(a) Using a snap ring expander, remove the snap ring.
(b) Place matchmarks on the shaft and tripod.
(c) Using a brass bar and hammer, remove the tripod from
the drive shaft.
NOTICE:
Do not tap the roller.
5. REMOVE INBOARD AND OUTBOARD JOINT BOOT
CLAMPS AND BOOTS
SA1443
NOTICE:
Do not disassemble the outboard joint.
6. REMOVE DUST DEFLECTOR
Using a screwdriver and hammer, remove the dust deflector.
FA0841
− FRONT DRIVE SHAFT (4WD)
SA0FZ−02