Toyota T100 1996 Service Manual page 1567

1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
SST
FA0785
SST
FA0784
SST
FA0831
SST
FA0830
90°
FA0880
− FRONT UPPER SUSPENSION ARM (4WD)
REPLACEMENT
1. REMOVE TORQUE ARM
2. REMOVE FRONT BUSHING
(a) Using a chisel and hammer, loosen the staked part of the
nut and remove the nut.
(b) Using SST and press, remove the front bushing.
SST 09710−26011 (09710−05041, 09710−05051)
3. REMOVE UPPER SUSPENSION ARM SHAFT
4. REMOVE REAR BUSHING
Using SST and press, remove the rear bushing
SST 09710−26011 (09710−05081),
09950−60010 (09951−00530),
09950−70010 (09951−07200)
5. INSTALL REAR BUSHING
(a) Using SST and press, install a new rear bushing.
SST 09710−26011 (09710−05061, 09710−05081)
HINT:
Do not apply grease or oil to the bushing.
(b) Install the upper suspension arm shaft.
6. INSTALL FRONT BUSHING
Using SST and press, install a new front bushing
SST 09710−26011 (09710−05061, 09710−05081)
7. TORQUE UPPER SUSPENSION ARM SHAFT
(a) Install the 2 retainers and new nuts.
HINT:
Position the upper suspension arm shaft so that the frame
installation surface is level with the suspension shaft arm.
(b) Torque the suspension arm shaft nuts.
Torque: 226 N·m (2,300 kgf·cm, 166 ft·lbf)
(c) Stake the nuts with a chisel and hammer.
8. INSTALL TORQUE ARM TO UPPER SUSPENSION
ARM
Torque: 87 N·m (890 kgf·cm, 64 ft·lbf)
SA−97
SA0H1−01