Toyota T100 1996 Service Manual page 1042

New Grommet
New O−Ring
New Grommet
Push
Turn
Rotate
1996 TOYOTA T100 (RM449U)
SFI (5VZ−FE)
INSTALLATION
1.
(a)
New O−Ring
(b)
P10889
(c)
(d)
Connector
P21185
(e)
(f)
(g)
P21208
(h)
Outward
HINT:
If injectors do not rotate smoothly, the probable cause is incor-
rect installation of O−rings. Replace the O−rings.
(i)
P21216
2.
3.
(a)
(b)
P21207
− INJECTOR
TEMPORARILY INSTALL INJECTORS AND
DELIVERY PIPES
Install 2 new grommets to each injector.
Apply a light coat of spindle oil or gasoline to 2 new O−
rings and install them to each injector.
While turning the injector clockwise and counterclock-
wise, push it to the delivery pipes. Install the 6 injectors.
Position the injector connector outward.
Place the 4 spacers in position on the intake manifold.
Place the delivery pipes with the 6 injectors in position on
the intake manifold.
Temporarily install the 4 bolts holding the delivery pipes
to the intake manifold.
Check that the injectors rotate smoothly.
Position the injector connector outward.
CONNECT INJECTOR CONNECTORS
INSTALL FUEL PIPE AND TIGHTENING
DELIVERY PIPE HOLDING BOLTS
Install the fuel pipe with 4 new gaskets and the 2 union
bolts.
Torque: 34.3 N·m (350 kgf·cm, 25 ft·lbf)
Tighten the 4 bolts holding the delivery pipes to the intake
manifold.
Torque: 13 N·m (130 kgf·cm, 10 ft·lbf)
SF−23
SF0C6−03