Toyota T100 1996 Service Manual page 1294

MT−14
MANUAL TRANSMISSION (R150, R150F)
x8
1996 TOYOTA T100 (RM449U)
7. 4WD:
FIPG
REMOVE TRANSFER ADAPTOR
(a) Remove the shift lever housing set bolt.
Torque: 38 N·m (390 kgf·cm, 28 ft·lbf)
(b) Remove the 10 bolts.
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
(c) Using a plastic hammer, tap the transfer adaptor, remove
the shift lever housing and the shift and select lever.
FIPG:
Q06901
Part No. 08826 − 00090, THREE BOND 1281 or
equivalent
8. REMOVE FRONT BEARING RETAINER
FIPG
(a) Remove the 8 bolts.
Sealant:
Part No. 08833 − 00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 17 N·m (170 kgf·cm, 12 ft·lbf)
(b) Using a plastic hammer, tap the front bearing retainer.
FIPG:
Part No. 08826 − 00090, THREE BOND 1281 or
Q06900
equivalent
9. REMOVE BEARING SNAP RING
Using a snap ring expander, remove the 2 snap rings.
10. SEPARATE INTERMEDIATE PLATE FROM TRANS-
MISSION CASE
FIPG
(a) Using a brass bar and hammer, carefully tap the transmis-
sion case.
(b) Remove the transmission case from the intermediate
plate.
HINT:
At the time of reassembly, please refer to the following item.
Align the each bearing outer race, each fork shaft end and re-
Q06903
verse idler gear shaft end with the case installation holes.
− MANUAL TRANSMISSION ASSEMBLY