Toyota T100 1996 Service Manual page 842

EM−14
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
14.
(a)
(b)
If not, turn the crankshaft pulley 1 revolution (360°).
P20829
HINT:
When re−using timing belt: Place the matchmarks on the timing
belt and camshaft timing pulleys, and place matchmark on tim-
ing belt to match the end of the No.1 timing belt cover.
P20826
15.
Alternately loosen the 2 bolts, and remove them, the belt ten-
sioner and dust boot.
P20818
16.
(a)
P20831
(b)
P20833
− TIMING BELT
SET NO.1 CYLINDER AT TDC/COMPRESSION
Turn the crankshaft pulley and align its groove with timing
mark "0" of the No.1 timing belt cover.
Check that the timing marks of the camshaft timing pul-
leys and No.3 timing belt cover are aligned.
REMOVE TIMING BELT TENSIONER
REMOVE RH CAMSHAFT TIMING PULLEY WITH TIM-
ING BELT
Using SST, loosen the pulley bolt.
SST 09960−10010 (09962−01000, 09963−01000)
Remove the bolt, knock pin and camshaft timing pulley
with timing belt.