Toyota T100 1996 Service Manual page 1677

BR−40
SST
SST
1996 TOYOTA T100 (RM449U)
REMOVAL
1.
Remove the inspection hole plug, and check the shoe lining
thickness through the hole.
If less than minimum, replace the shoes.
2.
R08164
3.
HINT:
If the brake drum cannot be removed easily, do the following
steps.
(a)
(b)
(c)
BR3096
4.
(a)
R04711
(b)
(c)
(d)
R04712
5.
(a)
(b)
SST
R04713
BRAKE − REAR DRUM BRAKE (2WD)
INSPECT SHOE LINING THICKNESS
Minimum thickness: 1.0 mm (0.039 in.)
REMOVE REAR WHEEL
REMOVE BRAKE DRUM
Remove the adjusting hole plug in the backing plate.
Insert a screwdriver through the hole in the backing plate,
and hold the automatic adjusting lever away from the ad-
justing bolt.
Using another screwdriver, reduce the brake shoe adjust-
ment by turning the adjusting bolt.
REMOVE FRONT SHOE
Using SST, disconnect the return spring.
SST 09703−30010
Using SST, remove the shoe hold−down spring, cups and
pin.
SST 09718−00010
Disconnect the anchor spring from the front shoe and re-
move the front shoe.
Remove the anchor spring from the rear shoe.
REMOVE ADJUSTER AND REAR SHOE
Using SST, remove the shoe hold−down spring, cups and
pin.
SST 09718−00010
Remove the adjusting lever spring.
BR09K−01