Toyota T100 1996 Service Manual page 1462

1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT
Matchmarks
PR0011
SST
PR0034
− PROPELLER SHAFT ASSEMBLY (4WD)
3. Rear:
INSTALL FLANGE ON INTERMEDIATE SHAFT
(a) Coat the splines of the intermediate shaft with MP grease.
(b) Place the flange on the shaft and align the matchmarks.
HINT:
If replacing either the center flange or intermediate shaft, reas-
semble it so that the front side flange yoke of the intermediate
shaft and the rear side flange yoke of the propeller shaft facing
in the same direction.
(c) Using SST to hold the flange, press the bearing into posi-
tion by tightening down a new nut.
SST 09330−00021
Torque: 181 N·m (1,850 kgf·cm, 134 ft·lbf)
(d) Loosen the nut.
(e) Torque the nut again.
Torque: 69 N·m (700 kgf·cm, 51 ft·lbf)
(f) Using a hammer and punch, stake the nut.
4. Rear:
INSTALL PROPELLER SHAFT
(a) Align the matchmarks on the flanges and connect the
flanges with 4 bolts, washers and nuts.
HINT:
If replacing either the center flange or intermediate shaft, reas-
sembly it so that the front side flange yoke of the intermediate
shaft and the rear side flange yoke of the propeller shaft are fac-
ing in the same direction.
(b) Torque the bolts.
Torque: 76 N·m (780 kgf·cm, 56 ft·lbf)
PR−15