Toyota T100 1996 Service Manual page 1426

TR−18
1996 TOYOTA T100 (RM449U)
TRANSFER − OIL PUMP BODY
DISASSEMBLY
1. CHECK OIL PUMP OPERATION
Install the oil pump drive gear to the drive rotor and check that
the drive rotor turns smoothly.
2. REMOVE STRAIGHT SCREW PLUG, SPRING, BALL
AND SEAT
(a) Using a hexagon wrench, remove the straight screw plug.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
HINT:
At the time of installation, apply liquid sealer to the plug.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
(b) Using a magnetic finger remove the spring and ball.
(c) Using SST, pull out the seat.
SST
(d) Remove the O−ring from the seat.
HINT:
At the time of reassembly, please refer to the following items.
Install a new O−ing to the seat.
S
When installing the seat, push the seat until it touches the
S
bottom of the hole in the body.
TF0547
3. REMOVE OIL PUMP PLATE
(a) Using a torx socket wrench (T30), unscrew the 3 torx
screws.
Torque: 7.4 N·m (75 kgf·cm, 65 in.·lbf)
(b) Remove the oil pump plate.
4. REMOVE DRIVE ROTOR AND DRIVEN ROTOR
HINT:
At the time of reassembly, apply gear oil to the both rotors.
TF0485
09921−00010
TR0D0−01