Toyota T100 1996 Service Manual page 1746

Compressed Air
Inscribed
Mark
SST
1996 TOYOTA T100 (RM449U)
STEERING
3.
(a)
Z14294
(b)
R09063
If necessary, replace the valve with one having the same letter
on the front housing.
R09064
4.
Using calipers, measure the free length of the spring.
If it is not within the specification, replace the spring.
Calipers
R08702
5.
(a)
NOTICE:
Be careful not to damage the bushing of the front housing.
(b)
Oil Seal
Z14483
− POWER STEERING VANE PUMP (3RZ−FE)
INSPECT FLOW CONTROL VALVE
Coat the valve with power steering fluid and check that it
falls smoothly into the valve hole by its own weight.
Check the flow control valve for leakage.
Close one of the holes and apply compressed air 392 −
490 kPa (4 − 5 kgf/cm
and confirm that air does not come out from the end hole.
Inscribed mark: A, B, C, D, E or F
INSPECT SPRING
Minimum free length: 32.3 mm(1.272 in.)
IF NECESSARY, REPLACE OIL SEAL
Using SST, tap out the oil seal from the front housing.
SST 09631−10030
Coat a new oil seal lip with power steering fluid.
2
, 57 − 71 psi) into the opposite side,
SR−39