Toyota T100 1996 Service Manual page 934

EM−106
Adhesive
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
P00496
Seal Width
2 − 3 mm
P10226
− CYLINDER BLOCK
22. INSTALL OIL FILTER (See page
23. INSTALL OIL PRESSURE SWITCH
(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Part No. 08833 − 00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(b) Using SST, install the oil pressure switch.
SST 09816−30010
Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)
24. INSTALL GENERATOR ADJUSTING BAR
Torque: 42 N·m (420 kgf·cm, 31 ft·lbf)
25. INSTALL WATER PUMP (See page CO−7)
26. INSTALL KNOCK SENSORS
Using SST, install the 2 knock sensors.
SST 09816−30010
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
27. INSTALL NO.2 IDLER PULLEY BRACKET
Torque: 38 N·m (380 kgf·cm, 28 ft·lbf)
28. INSTALL WATER BYPASS PIPE WITH KNOCK SEN-
SOR WIRE
(a) Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the bypass
and cylinder block.
Using a razor blade and gasket scraper, remove all
S
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
Thoroughly clean all components to remove all the
S
loose material.
Using a non−residue solvent, clean both sealing
S
surfaces.
(b) Apply seal packing to the groove of the bypass pipe.
Seal packing:
Part No. 08826 − 00100 or equivalent
Install a nozzle that has been cut to a 2 − 3 mm (0.08
S
− 0.12 in.) opening.
HINT:
Avoid applying an excessive amount to the surface.
LU−3 )