Toyota T100 1996 Service Manual page 1562

SA−92
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
REMOVAL
1. REMOVE FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
2. REMOVE BRAKE CALIPER (See page BR−27)
3. w/ ABS:
DISCONNECT ABS SPEED SENSOR WIRE FROM UP-
PER SUSPENSION ARM
Torque:8.0 N·m (82 kgf·cm, 71 in.·lbf)
4. REMOVE UPPER BALL JOINT FROM UPPER SUS-
PENSION ARM
(a) Support the lower suspension arm with a jack.
(b) Remove the 4 nuts and bolts, and disconnect the upper
suspension arm.
Torque: 31 N·m (320 kgf·cm, 23 ft·lbf)
R04506
5. REMOVE UPPER SUSPENSION ARM
(a) Remove the 2 bolts and camber adjusting shims.
Torque: 96 N·m (980 kgf·cm, 71 ft·lbf)
(b) Remove the upper suspension arm.
NOTICE:
Do not loose the camber adjusting shims. Record the
S
position and the thickness of camber adjusting shims
so that these can be reinstalled to their original loca-
tion.
FA0126
At the times of installation, install an equal number
S
and thickness of shims in their original position.
− FRONT UPPER SUSPENSION ARM (2WD)
SA0GW−07